Roberts Radio Clock Radio CR9951 User Guide

CR9951  
3 Band Single Alarm  
Clock Radio  
Please read this manual before use  
 
Controls  
(Front)  
13  
14  
17  
16  
15  
16. Rating plate (underside)  
17. Alarm indicator  
13. PM indicator  
14. LED dial pointer  
15. Battery compartment (underside)  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
2
 
Switching on and setting the time  
Before using your clock radio you must first set the correct time.  
1. Check that the supply voltage agrees with the voltage indicated  
on the rating plate on the bottom of the product. Place the unit on a  
flat surface. Plug the power cord into the wall socket and switch  
on.  
2. The clock display will flash 12:00.  
3. Press and hold down the Time Set button.  
4. Whilst holding down the Time Set button press the Hour, or  
Minute buttons to set the time. Release the buttons when the  
correct time is reached. The clock uses a 12 hour display with a  
PM indicator. Ensure that the correct 12 hour cycle is selected.  
3
 
Listening to the Radio  
1. Turn on the radio by sliding the Function switch to the 'On '  
position. The LED dial pointer will light up indicating that the  
radio is switched on.  
2. Select the required waveband using the Waveband selector  
switch.  
3. Tune in to the desired station by rotating the Tuning control.  
The station frequency is indicated by the LED dial pointer.  
The Wire aerial located on the rear of your clock radio is for FM  
reception. The wire should be fully extended and positioned for  
optimum reception.  
For MW and LW reception there is a built-in ferrite aerial. Rotate  
your clock radio to the position giving best reception.  
4. Adjust the volume by rotating the Volume control.  
5. The radio can be switched off by sliding the Function switch to  
the 'Off ' position.  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
4
 
Alarm  
The alarm can be set to wake you by either the buzzer or the radio.  
Setting alarm time  
1. Press and hold down the AL.Set/off button  
2. Whilst holding down the Alarm Set button/Off button press  
the Hour, or Minute buttons to set the time. Release the buttons  
when the correct alarm time is reached. The clock uses a 12 hour  
display with a PM indicator. Ensure that the correct 12 hour  
cycle is selected.  
Checking the alarm time  
1. To check alarm time, press and hold down the Alarm Set button/  
Off button the display will show the alarm time  
5
 
Setting the alarm to wake to buzzer  
1. Set the alarm time as previously described. Set the Function  
switch to the 'Buzz' position. The Alarm indicator will light.  
The alarm will sound every day at the preset time for 1 hour 59  
minutes. To turn off the alarm until the next day press the AL.Set/  
off button To turn off the alarms permanently set the Function  
selector to the 'Off' position.  
Setting the alarms to wake to radio  
1. Set the alarm time as previously described. Set the Function  
switch to the 'Auto' position. The Alarm indicator will light.  
Ensure that the volume is set to the correct level and the desired  
station is tuned in.  
The alarm will sound every day at the preset time for 1 hour 59  
minutes. To turn off the alarm until the next day press the AL.Set/  
off button To turn off the alarms permanently set the Function  
selector to the 'Off' position.  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
6
 
Snooze control  
The radio or buzzer alarm can be silenced for 9 minutes by pressing  
the Snooze button. This sequence can be repeated whilst the alarm  
is sounding.  
Sleep timer  
The radio can be set to turn off after a preset time has elapsed.  
Press and hold down the Sleep button until the desired time is reached  
(maximum 59 minutes in 1 minute steps). The radio will switch off after  
the sleep time has elapsed.  
To cancel the sleep function before the preset time has expired, press  
the Snooze button.  
Dimmer Switch  
The Dimmer switch located on the left side of your clock radio will allow  
you to adjust the intensity of the clock display to suit room brightness.  
7
 
Headphones (on rear)  
A Headphone Socket (3.5mm) is provided for use with either  
headphones or an earpiece . Inserting a plug automatically mutes  
the internal loudspeaker.  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
8
 
General  
Fuse  
Do not allow this unit to be exposed to water or steam. It is recommended  
that the FM band be used wherever possible as better results in terms  
of quality and freedom from interference will usually be obtained than  
on the MW or LW bands.  
This apparatus must be protected by a 3Afuse (BS1362) in a 13Aplug  
(BS1363). If another type of plug is used a 5A fuse should be fitted in  
the plug, adaptor or distribution board.  
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.  
Mains supply  
Back-up Battery (not necessary for the unit to function)  
Slide the battery cover catch in the direction of the arrow. Remove the  
battery cover. Fit a 9 volt IEC size 6LR61(6F22,PP3) or equivalent  
battery into the compartment. Replace the battery cover.  
The CR9951 will operate from a supply of AC 230volts, 50Hz  
only as advised on the rating plate on the cabinet bottom.  
For your convenience this product is supplied with a plug which is  
fitted with a fuse of the appropriate rating. If the plug supplied is not  
suitable for your socket outlet, it should be removed by unscrewing the  
plug top, the terminal screws, and removing the cable.  
The time and alarm settings will be retained during a temporary failure  
of the AC mains supply. The LED display will not be operational. The  
display will be extinguished to conserve battery life.  
The correct style of plug to suit your household together with a correctly  
rated fuse should be fitted.  
IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN  
IMPORTANT. DO NOT make any connection to the larger terminal which  
(Underside)  
is marked with the letter E or by the safety earth symbol  
Green or Green-and-yellow.  
or coloured  
The wires in the mains lead are coloured in accordance with the following  
codes :-  
BLUE - NEUTRAL  
BROWN - LIVE  
As these colours may not correspond with the coloured markings  
identifying the terminals in your plug, proceed as follows:-  
The wire coloured BLUE must be  
connected to the terminal marked  
N or coloured BLACK.  
The wire coloured BROWN must  
be connected to the terminal  
marked L or coloured RED.  
9
 
Specifications  
Circuit Features  
Power Requirements  
Mains  
Loudspeaker  
Output Power  
Aerial System  
75mm diameter 8 ohms  
0.3W RMS  
AC 230 volts, 50Hz  
IEC size 6LR61 (6F22,PP3)  
only  
Back-up Battery  
FM  
Wire Aerial  
Frequency Coverage  
FM  
MW  
LW  
87.5 - 108MHz  
525 - 1610kHz  
147 - 284kHz  
MW  
LW  
Built-in Ferrite aerial  
Built-in Ferrite aerial  
The Company reserves the right to amend the specification without notice.  
If you need any further advice, please call our Technical Helpline on :-  
020 8758 0338 (Mon-Fri)  
10  
 
Guarantee  
This radio is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component  
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced  
free of charge.  
The guarantee does not cover:  
1. Damage resulting from incorrect use.  
2. Consequential damage.  
3. Product with removed or defaced serial numbers.  
Procedure: Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your  
Roberts' dealer will be able to attend to any defect quickly and efficiently but should it be necessary the dealer will return the instrument to the  
company' service department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was  
purchased, please contact Roberts Radio Technical Services at the address shown below.  
These statements do not affect the statutory rights of a consumer.  
ROBERTS RADIO TECHNICAL SERVICES  
97-99 Worton Road  
Isleworth Middlesex  
TW7 6EG  
Issue 1  
Technical Helpline :- 020 8758 0338 (Mon-Fri during office hours)  
 

PYLE Audio VCR PLTVCP85 User Guide
Radio Shack Microphone 33 3024 User Guide
Radio Shack Motorized Toy Car 60 4360 User Guide
Radio Shack Watch 63 5026 User Guide
Rangemaster Freezer U110120 01A User Guide
Raypak Boiler 241275 User Guide
Raypak Swimming Pool Heater R265B User Guide
Rheem Water Heater Commercial Power Direct Vent Water heater User Guide
Samsung Printer ML 6100 User Guide
Sears Electric Heater 583356 User Guide