Schumacher Power Supply 00 99 000674 User Guide

Schumacher Electric Corporation  
Model IP-1850FL  
OWNER’S MANUAL  
INSTANT POWER™ Jump Starter & DC Power Source  
THIS PRODUCT HAS A SEALED LEAD-ACID BATTERY INSIDE THAT SHOULD BE KEPT AT FULL CHARGE FOR LONGER LIFE.  
RECHARGE WHEN FIRST RECEIVED (EVEN IF GREEN ‘FULL POWER’ LED GLOWS), AFTER EACH USE AND EVERY 3 MONTHS.  
IMPORTANT SAFETY INSTRUCTIONS  
Save these instructions  
clamp (+) in that order. Store the clamps on the ears located  
on the sides of the case.  
11. Recharge the IP-1850FL as soon as possible after use.  
important safety instructions  
Someone should be within range of your voice or close enough to  
come to your aid when you are working near a lead-acid battery.  
*NOTE: In the rare case of jump-starting a vehicle that has  
Have plenty of fresh water and soap nearby in case battery acid  
contacts skin, clothing, or eyes. If acid enters the eye area,  
rinse with cold water for at least 10 minutes and get medical help  
immediately.  
a positive-grounded vehicle electrical system, connect the  
NEGATIVE black clamp (-) to the negative terminal (-) of the  
vehicle battery. Then connect the POSITIVE red clamp (+)  
to an unpainted and unmoving part of the vehicle chassis or  
engine block. If you are unsure of the nature of the vehicle’s  
electrical grounding system, check the owner’s manual of the  
vehicle. To disconnect clamps, reverse order.  
Do not smoke, or use matches or cigarette lighter, or allow any  
spark or flame near the battery or engine.  
Never operate the power source unit if it has damaged lead wire or  
clamps. Have the lead wire replaced by a qualified technician.  
led indicators  
Wear complete eye and clothing protection when working with  
lead-acid batteries.  
To check the internal battery’s charge status, press the red button  
on the front of the IP-1850FL.  
Do not permit the internal battery in the IP-1850FL to freeze. Never  
attempt to recharge a frozen battery.  
The LED lights will indicate the charge level as follows:  
1. A red LED indicates a 50% or less charge and you should  
immediately recharge.  
2. A yellow LED indicates a 50 to 75% charge. The IP-1850FL  
may be used but should be recharged as soon as possible.  
handling warning  
WARNING: Handling the cord on this product or cords associated  
with this product, may expose you to lead, a chemical known to  
the State of California to cause cancer and birth defects or other  
reproductive harm. Wash hands after handling.  
3. A green LED indicates the internal battery is charged.  
charging of internal battery with built-in charger.  
After removing the IP-1850FL from the carton, charge it for a  
minimum of 8 hours before using even if the green Full Power  
LED glows.  
operating instructions  
Warning: Failure to follow instructions may cause  
damage or an explosion. Read entire instruction  
manual before use.  
NOTE: The ON/OFF switch does not have to be in the ON position  
to recharge the internal battery.  
1. Turn ignition OFF before making cable connections.  
2. Use in a well-ventilated area.  
3. Keep clear of fan blades, belts, pulleys and other parts that  
may cause injury.  
4. Make sure the power ON/OFF switch is in the OFF position  
until clamps are connected to the vehicle battery.  
5. In the ON position, NEVER allow clamps to touch together or  
to contact the same piece of metal to prevent sparking.  
6. Clamp the red clamp (+) to the positive terminal of the battery.  
(For a negative grounded system.)*  
7. Clamp the black clamp (-) to an unpainted and unmoving part  
of the chassis or engine block.  
8. If you have connected the clamps of the IP-1850FL backwards,  
an audio alarm will sound. DO NOT turn your IP-1850FL on.  
This could cause serious damage. Reverse the connections,  
and the audio alarm will stop.  
1. To charge, plug extension cord into charger plug on the back  
of the IP-1850FL. (Extension cord not included; must be  
purchased separately.)  
2. Plug the extension cord into 110V AC electrical wall outlet.  
3. The red LED will glow indicating charging.  
4. The green LED will glow when the battery has reached full  
charge. This could take up to 72 hours on some charges due to  
age and condition of the battery. The charger will automatically  
drop into a float mode and maintain the battery at full charge  
without damaging the battery. The IP-1850FL can be left  
plugged into the 110V wall outlet indefinitely to maintain full  
power.  
5. Recharge the IP-1850FL after use and every 3 months to full  
charge status to extend the battery’s life.  
multi-purpose power supply  
The IP-1850FL is a power source for all 12 volt power accessories  
with 12V accessory plug. Make sure the device to be powered  
is OFF before inserting 12 volt accessory plug into 12 volt DC  
accessory outlet located on the front of the IP-1850FL. Use the 12  
volt accessory outlet for power outages, fishing and camping trips,  
cell phones, camcorders, computers, etc. Estimate usage time is  
listed in chart below.)  
9. If no audio alarm is sounded, turn ON the IP-1850FL, and  
then crank the engine. If the engine does not start within  
5 – 8 seconds, wait at least 1 minute before attempting to start  
vehicle again. (This permits the battery to cool down.)  
10. After the engine starts, make sure to turn OFF the power  
switch. Then disconnect the black clamp (-) and then the red  
00-99-000674/1106  
 

Radica Games Games 75011 User Guide
Radio Shack Switch AFX 400 User Guide
Ricoh Printer MP 1600 MP 2000 User Guide
Rockford Fosgate Stereo Amplifier T400 2 User Guide
Rotel CD Player RCD 950 User Guide
Royal Sovereign Air Conditioner ARP 2412 User Guide
Samsung Cell Phone GH68 06114A User Guide
Samsung Cordless Telephone SP R6100 User Guide
Samsung Oven BF64CCBB User Guide
Sears Range 22 90832 User Guide